Try mem=96000k. I had some funky things happen when I try to use 'M' for megabytes, but I haven't been able to reproduce it again since so I can figure out why. Also, I use the amount that is displayed during the hardware boot process. If it says "98,304kb ok" that is the value I use. "mem=98306k" jose sanchez wrote: >I tried it and still doesn't work. > > > > >--- Jeremy Fowler wrote: > >>It's mem=96M (case sensitive and loose the b) >>-Jeremy >> >>>-----Original Message----- >>>From: owner-kclug@marauder.illiana.net >>>[mailto:owner-kclug@marauder.illiana.net]On Behalf >>> >>Of jose sanchez >> >>>Sent: Monday, December 17, 2001 10:26 AM >>>To: kclug@kclug.org; nylug-talk@nylug.org >>>Subject: Lilo >>> >>> >>>Hello: >>> >>>I have a little problem: >>> >>>I have 96mb of memory, Linux is only detecting or >>>reading 64mb. I added append="mem=96mb" in the >>>lilo.conf file; reinstalled lilo by typing lilo >>> >>and >> >>>even restarted the system but the kernel is still >>>reading 64mb. Why is this happening? Any one? >>> >>>Thanks in advance for your help. >>> >>> >>> >>>__________________________________________________ >>>Do You Yahoo!? >>>Check out Yahoo! Shopping and Yahoo! Auctions for >>> >>all of >> >>>your unique holiday gifts! Buy at >>> >>http://shopping.yahoo.com >> >>>or bid at http://auctions.yahoo.com >>> >>> >>>KC Linux Users Group -- to unsubscribe send mail >>> >>to majordomo@kclug.org >> >>>Enter without the quotes in body of message >>> >> >> >>majordomo@kclug.org >>Enter without the quotes in body of message >> > > >__________________________________________________ >Do You Yahoo!? >Check out Yahoo! Shopping and Yahoo! Auctions for all of >your unique holiday gifts! Buy at http://shopping.yahoo.com >or bid at http://auctions.yahoo.com > > > -- At 20, I was liberal, because I had nothing to lose and so much to gain. by 40, I was conservative, because I had so much to lose and so little to gain. Isn't it amazing what 20 years of hard work and experience will do for ones' point of view?