I have one running great on Debian Potato. Have you used the tulip drivers what come with the card? They are a bit newer than what was in my Potato. pci-scan and tulip were both required. Also, have you updated your modules file or insmod'ed them? Mike Coleman wrote: > > "Matthew Austin" writes: > > Debian 2.2.18pre21, i386 System board: Gigabyte GA-7IX > > > > I have a Linksys (LNE100TX) card, which is a PCI card. It should use tulip.o, > > but when I try to install this module I get a "device or resource busy error". > > Looking at proc/pci, I see the card is detected but it never gets configured > > as eth0. When searching the archives of linux.debian.user, I have found > > several ideas that either didn't work or I don't understand. > > That error message would usually indicate that the module's init routine > failed. Looking at the driver source, that would seem to mean that the probe > routine didn't like it for some reason or another. > > Are there any other error messages, maybe in one of the logs? You could try > adding some debugging printk's into those routines to see exactly how and > where it's failing. > > --Mike > > -- > Mike Coleman, mkc@mathdogs.com > http://www.mathdogs.com -- problem solving, expert software development >