Subject: Re: Problems with compile of Mitsumi driver 0.99pl9 From: PAUL.P.A.WILKINSON@BHPMELMSM.BHP.bhpmel04.telememo.au (Paul Wilkinson) Date: 10 May 1993 12:48:50 +1000
In article <9305065088@clifton.hobby.nl>, baron@clifton.hobby.nl (Wim `Blue
Baron' van Dorst) wrote:
>
> p.ing.fennema (pfennem@cbnewsk.cb.att.com) wrote:
>
> : Also, when I have the kernel compiled with the scsi driver and the
> : mitsumi driver it still does not recognise the mitsumi.
>
> I have no Mitsumi yet, so I pass on this one.
>
I had a problem with this when I moved to .99pl9. Are you getting a
message at boot time saying "MCD - No drive found" or are you just not
getting any message from the MCD driver. In my case it was the latter.
The cause was a failed patch which did not install mcd_init() into
the main initialisation routine for the Kernel.
If you are getting a message saying the drive is not found then it
may be the base address or IRQ coded in mcd.c is not correct.
Regards,
Paul
===================================================================/\/\===
Paul Wilkinson, MVS System Programmer, Facilities Management / / /\
BHP Information Technology, Wollongong Region / / / \
Mail : P.O. Box 261, Warrawong 2502, NSW, Australia / / / /\ \
Telephone : +61 42 757522 ext 6163 Fax: +61 42 757801 \ \/ / / /
Internet : PAUL.P.A.WILKINSON@ \ / / /
BHPMELMSM.BHP.bhpmel04.telememo.au \/\/\/
==========================================================================
Any opinions expressed here are figments of my own imagination