From: sinn@carson.u.washington.edu (Philip Sinn) Subject: Xconfig problem on my ET4000 VL-BUS and NEC 3D. Date: 1 May 1993 02:06:10 GMT
I installed the SLS packages and tried to run the X window.
I can get it to start with a Xconfig that from
the system with 800x600 and 1024x768i, however, when
the default xterm or xclock goes up, it occupied the almost the
whole screen in both resolutions.
xclock: supposed to be 80x80, but it used up 1/8 of the screen
when opened
xterm: I can only see 28 characters at a time, I need to
pan to see the rest of the line which is off the screen.
I thought that it should come up with a 1024x768 resolution, so
the 80x80 should be very small piece on the screen.
If I can't see a full xterm, how can I use it then to do vi or
etc...
Did I do something wrong? Please help?
Philip Sinn
sinn@carson.u.washington.edu
University of Washington