From: thssrkr@iitmax.iit.edu (Raghunath K. Rao) Subject: Console SVGA setting (How to change) Date: Wed, 16 Jun 1993 00:55:19 GMT
Hi!
I setup the SLS 1.02 with a particular SVGA console setting
(80x132) and now, once it has been installed, I find that
X screws up the display once killed. However, I remember that
with a 80x50 console screen, it used to sync properly even
after exiting X. Problem is that the machine always boots
up on the 80x132! How to change the configuration for boot?
Or for that matter, after booting too?
Raghu
=====================================================================
_____ ___ _______
K. RAGHUNATH RAO /____/ \ /__/\ /______/\
email : thssrkr@iitmax.iit.edu | __ \ /| / _ \ \ / ___ \ |
sleepy (res) : (312)791-9428 | |__) |/ / /_\ \ \ | / | \ | |
sleepier (off) : (312)567-3407 | __ /\ | ___ | | | | | | | |
| | \ \ \ | / | \ | | | | |_| | |
It is the intonation and not | | |\ \ \ | | | | | | | \/__/ |/
the intention that matters!! |_|/ \_\/ |_|/ |_|/ \______/
=====================================================================