From: hartnegg@sun1.ruf.uni-freiburg.de (Klaus Hartnegg) Subject: Lilo 0.7 printing only "LI" Date: Thu, 7 Jan 1993 14:52:23 GMT
Hi,
I need help with lilo 0.7
The previous version of lilo worked great until I upgraded
the linux kernel. With the new kernels we need lilo 0.7.
So far so good.
So I downloaded, compiled and installed it.
It works great on my computer at home (mfm hard disk).
But in the university (at bus/ide hard disk) it prints
only "LI" instead of "LILO" and the computer hangs.
I used exactly the same source both times.
Both computers were installed starting with hlu's
boot and base disks, then I added GCC from the SLS disks.
I erased the etc/lilo directory and recreated it by
copying lilo, boot.b and chain.b there from /usr/src/lilo.
On one computer it works, on the other not.
Any ideas?
-- ============================================================================== Klaus Hartnegg, Kleist-Str. 7, D-7835 Teningen, Germany hartnegg@sun1.ruf.uni-freiburg.de or hakl@ibm.ruf.uni-freiburg.de Disclaimer: this text reflects MY opinion, not that of my employer!