From: wto@cbnewsg.cb.att.com (William T. O Connell) Subject: "man" :command not found Date: Sat, 2 Jan 1993 23:05:41 GMT
I have been having no problem with man in the past, but after
updating to .99p2, get the following message.
$man uucp
: command not found
$
This just started to happen with the updated version (.99p2), though
I wouldn't think that it would have anything to do with it???
If I pass some bogus manual page name to man, it says man page not
found as expected.
Any clues what started causing this? (I'm stumped)
- Bill O'Connell wto@ihlpx.att.com