From: inu574f@lindblat.cc.monash.edu.au (Mark Cosham) Subject: Re: [HELP] Stacker3.0 and DOS6, with doemu... Date: Mon, 9 Aug 1993 06:55:52 GMT
cws9669@ultb.isc.rit.edu (C.W. Southern) writes:
>Anyone out there have Stacker 3.0 and DOS 6.0 running under dosemu? The
>problem is for some reason when stacker is loaded from the CONFIG.SYS it
>can't find the stac volume (stacvol.dsk). Here is the layout of the system:
>Under dosemu:
> Drive C: (Boot, hdimage)
> Drive D: (Dos Drive)
> Drive E: (Linux Drive)
> Drive F: (The stack drive of DOS, well not yet)
>I have the following lines in my c:config.sys:
>device = d:\stacker\stacker.com d:\stacvol.dsk
>device = d:\stacker\sswap.com d:\stacvol.dsk /SYNC
>The problem is with the first line. When stacker loads, it goes through
>its opening comments and then says.
>F: = D:stacvol.dsk Cannot find STACVOL file - NO MOUNTED
>Then it tries to sswap them and fail.. The d:stacvol.dsk file is there. The
>file is over 100meg could that be the reason it can't be found by the stacker
>program? Maybe its a dosemu problem with large files? Any suggestions..
>chris.
>--
> ___ Internet: cws9669@ultb.isc.rit.edu
> / / __ cws9669@cs.rit.edu
> / /--- /-- . ( BITNET: CWS9669@RITVAX
> \__ / / / / __) UUCP: !uucp!rit!cws9669
I'm using Stacker V2.0, and I couldn't get it to find the stacvol file
from a dos drive that was mounted on the linux partition, and emufs used
to mount it unter the emulator. My fix was to let dos use the partition
directly - not through the linux file system.
Mark Cosham
--
Practice random kindness and senseless acts of beauty.
===========> <=======> <=======> <=======> <=======> <=======> <===========
Mark Cosham Monash University, Melbourne, Victoria, Australia
cosham@yoyo.cc.monash.edu.au inu574f@aurora.cc.monash.edu.au