From: root@umibox.hanse.de (Bernd Meyer) Subject: Re: Wangtek PC02 SCSI controller not detected at boot. Date: Sun, 1 Aug 1993 12:39:07 GMT
scott@geom.umn.edu (Scott S. Bertilson) writes:
> This is a *very* confusing question. It is very unlikely that you
>have a SCSI tape drive and Wangtek PC02 controller. It is more likely
>that you have a QIC-02 tape drive and a PC-36 controller in which case
>it is well supported by the QIC-02 driver that is included in 99PL11.
>I haven't upgraded for awhile, but previous versions of the driver
>have served me very well.
It is also possible that Wangtek has started cloning the ST-02 just as
Syquest is said to have done. If so, it should be sufficient to OVERRIDE the
base adress of the ST-02 driver to recognize it. But only do this after you
are sure you know what you are doing.....
Maybe booting DOS, debug and "g=c800:5" will tell you more.
Bernie
-- We both know that the earth is round | Bernd Meyer, EE-student So we can't see the way before us to its end | "Nobody is a failure who has We walk on this way, hand in hand, | friends" (from: isn't it a And I hope you are still with me behind the horizon| wonderful life?"