From: vladimir@intrepid.com (Vladimir Vukicevic) Subject: Re: Installing SLS on IBM ValuePoint Date: Sun, 11 Apr 1993 01:33:29 GMT
In article <93098.084857ALC@psuvm.psu.edu> <ALC@psuvm.psu.edu> writes:
>Has anyone tried yet to install SLS on an IBM Valuepoint? I can't get
>FDISK to access the harddisk. Just says - "Can't read /dev/hda"
>
>Also, someone else asked this question but I did not see a response:
>Where is the list of supported Ethernet cards - I'm specifically using
>a 3com 3C503 but SLS doesn't seem to have this card in it's preinstalled
>configuration.
>
>Thanks
>
Well, if the ValuePoint uses SCSI, you need to say 'fdisk /dev/sda'. If
it does not use SCSI, the main disk might be /dev/hdb, so 'fdisk /dev/hdb'.
Try both. You can't hurt anything. (if neither work, you might want to try
/dev/sdb)
- Vladimir
-- #---- Vladimir Vukicevic #include <std_disclaimer.h> #--------- vladimir@intrepid.com #--------