From: haerter@elysium.novalis.public.sub.org (Otto Haerter) Subject: Re: Another patch to new scsi code uploaded. Date: Mon, 21 Dec 1992 15:26:59 CET
In article <By8q93.BE6@ra.nrl.navy.mil> eric@tantalus.nrl.navy.mil (Eric Youngdale) writes:
> I just uploaded fscsi-a06.patch2, which contains a few more minor
>patches to the scsi code, and it is on tsx-11.mit.edu in pub/linux/ALPHA/scsi.
Does anybody know whether LINUX supports an ATBUS harddisk together with
an ADAPTEC 1542 B and a SYQUEST for example.
I have setup MS-DOS 5.0 at the PC and I need the ADAPTEC and the SYSQUEST
under DOS, but more space for LINUX would not be too bad also.
But if I put the ADAPTEC board into the PC and connect the SYQUEST, the
system hung if in booting sequence for LINUX you can read:
SCSI host detected or so.
The LED on the ADAPTEC board in on at this moment.
Problems on my system:
I cannot run LINUX from the ATBUS harddisk yet (problems with doinstall, with
the new bootdisk I get a cold reset with memory test, or system stops with
a general protection failure, the different errors occured, after I had chosen
to install whole base system or base and X 11.
Are there running systems from the IDE-harddisk with an extra ADAPTEC ?
Probably another problem on my system: A ARTISOFT (Lantastic)
Ethernet-Adapter is plugged in also. (IRQ 10, ADAPTEC is on default (IRQ 11)
>
>--
>Eric Youngdale
tschuess,
Otto