From: hanst@htsa.aha.nl (Hans Trompert) Subject: ST01 problems (Was: help with Maxtor M7080S and ST01. Date: 2 Aug 1992 17:22:12 GMT
In article <1992Jul30.133634.1897@athena.mit.edu> caffrey@salem.salem.ge.com writes:
>I just received a new Maxtor M7080S scsi disk and am unable to
>get it to work. I am using an ST01 controller which I have been
>using for the past few months with a seagate ST157N with no problems
>( except that it was slow ).
>
>During Boot up the ST01 reports that it finds a disk, but linux
>reports 0 Disks 0 tapes total.
I have the same kind of problem with a ST01 controller, only with
two other disks: a Quantum Pro 80S and a Micopolis (I cann't remember
the type right now). Under MSDOS I'm able to use both disk, but
when booting Linux 0.96c-pl2 it does detect the controller but reports
it cann't find any disks (or tapes for that matter).
I toke a look at the autodetect-code in scsi.c, and even enabled some
debug output, but couldn't find anything wrong (at first sight).
I'm really stuck right now. Is there anybody out there who has any
idae what is going wrong ? Every bit of information is welcom !
Regards,
Hans Trompert (hanst@htsa.aha.nl).